Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6647 PID: SPN: 6780 FMI: 3 Aftertreatment 1 Diesel Particulate Filter Soot Temperature Sensor - Voltage Above Normal Or Shorted To High Source. An Internal Circuit Error Has Been Detected By The Aftertreatment P (2024)

Table of Contents
Related Related products

Shop

Account

Cart$0.00

Subtotal: $0.00

No products in the cart.

Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6647 PID: SPN: 6780 FMI: 3 Aftertreatment 1 Diesel Particulate Filter Soot Temperature Sensor – Voltage Above Normal or Shorted to High Source. An internal circuit error has been detected by the aftertreatment particulate matter sensor.

Circuit Description
The aftertreatment particulate matter sensor is a smart device and communicates with the engine control module (ECM) via the J1939 data link. The aftertreatment particulate matter sensor performs internal diagnostics and reports malfunctions back to the primary ECM using the J1939 data link. The particulate matter sensor is permanently attached to the particulate matter control module. They are serviced as a single component and can not be replaced individually. The aftertreatment particulate matter sensor is used to measure the soot emissions at the outlet of the aftertreatment system.

Component Location
The aftertreatment particulate matter sensor location can vary depending on engine application. It is usually located in the exhaust system at the outlet of the selective catalytic reduction (SCR) catalyst.

Conditions for Running the Diagnostics
This diagnostic runs continuously when the engine is running.

Conditions for Setting the Fault Codes
An internal circuit error was detected in the aftertreatment particulate sensor assembly

Action Taken When the Fault Code is Active
The ECM illuminates the amber CHECK ENGINE lamp and/or Malfunction Indicator Lamp (MIL) after the diagnostic fails on two consecutive trips.

Conditions for Clearing the Fault Code
1)To validate the repair, start the engine and let it idle for 1 minute.
2)The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs and passes.
3)The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
4)For On-Board Diagnostics (OBD) engines, the ECM will extinguish the Malfunction Indicator Lamp (MIL) after three consecutive trips where the diagnostic runs and passes.
5)The Reset All Faults command in INSITE? electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.

Possible causes :
1)Malfunctioning aftertreatment particulate matter sensor

Related

Categories Cumminz, ISB6.7 CM2350 (2013-17)Tags 1, 17, 2013, 3, 6647, 6780, Above, Aftertreatment, an, been, by, Circuit, CM2350, Code, Cummins, Detected, Diesel, Error, Fault, Filter, FMI, has, High, Internal, ISB6.7, Matter, Normal, or, Particulate, PID, Sensor, sensor., Shorted, soot, Source, SPN, Temperature, the, to, Voltage

Wiring Diagrams

Component Locators

  • VOLVO PREMIUM TECH TOOL PTT 2.7.30 Developer + Devtool + INSTALATION VIDEO!

    Trucks software$60.00

    Rated 0 out of 5

  • 2021 VOLVO PREMIUM TECH TOOL PTT V2.8.21 VCADS+DEVELOPER TOOL+APCI 2021/09 ( 1 PC )

    Trucks software$85.00

    Rated 0 out of 5

  • download JPRO 2023 1.2 off-highway – on-highway

    JPRO$96.00

    Rated 0 out of 5

  • PF Diagnose$60.00

    Rated 0 out of 5

  • Volvo Premium Tech Tool PTT 2.8.130 Diagnostic Software 04.2022 ACPI ( 1 PC )

    Trucks software$143.00

    Rated 0 out of 5

  • Volvo I-Shift service manual PDF

    TRUCK MANUALS$55.00

    Rated 0 out of 5

  • HINO EPC 2018 TRUCKS / BUSES 2018 EPC PARTS CATALOG

    Hino$85.00

    Rated 0 out of 5

  • Volvo Penta EPC 6 Offline VMware [12.2021] VMware

    Trucks software$64.00

    Rated 0 out of 5

  • Bendix 6.16 ACom Diagnostics ( bendix software trucks )

    Bendix$35.00

    Rated 0 out of 5

  • Detroit$30.00

    Rated 0 out of 5

  • ZF Testman Pro ESB 10.5 2022

    Trucks software$200.00

    Rated 0 out of 5

  • Cat Factory Password Generator 1.0 2019 WINDOWS 10

    CAT$55.00

    Rated 0 out of 5

  • VOLVO PREMIUM TECH TOOL PTT 2.7.30 Developer + Devtool + INSTALATION VIDEO!

    Trucks software$60.00

    Rated 0 out of 5

  • Diamond Logic Builder DLB 2018

    Navistar$40.00

    Rated 0 out of 5

  • Eaton Service Ranger 4 4.2 database 2017

    Eaton$50.00

    Rated 0 out of 5

  • Wabco PIN Code Calculator Diagnostic Software PIN 1 PIN 2

    Trucks software$10.00

    Rated 0 out of 5

  • Magic Tuner [paccar, Maxxforce, Detroit, Caterpillar, Delete]

    Magic Tuner$50.00

    Rated 0 out of 5

  • International Truck ISIS – Oncommand Service Information Q4.2020 [04.2020]

    Navistar$85.00

    Rated 0 out of 5

  • Hino DX3 1.22.10 2022 ( 1 PC )

    Hino$96.00

    Rated 0 out of 5

  • Volvo Premium Tech Tool PTT 2.8.130 Diagnostic Software 04.2022 ACPI ( 1 PC )

    Trucks software$143.00

    Rated 0 out of 5

Related products

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3251 PID:S326 SPN:4765 FMI:0 Aftertreatment Diesel Oxidation Catalyst Intake Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3253 PID: SPN:3242 FMI:0 Aftertreatment Diesel Particulate Filter Intake Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3245 PID: SPN:3936 FMI:7 Aftertreatment 1 Diesel Particulate Filter System – Mechanical System Not Responding or Out of Adjustment

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3235 PID: SPN:4363 FMI:16 Aftertreatment SCR Outlet Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:325 PID:SID 6 SPN:656 FMI:5 Injector Solenoid Driver Cylinder 6 Circuit – Current Below Normal or Open Circuit

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3316 PID: SPN:3242 FMI:4 Aftertreatment 1 Diesel Particulate Filter Intake Temperature Sensor Circuit – Voltage Below Normal or Shorted to Low Source

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3311 PID: SPN:3242 FMI:0 Aftertreatment 1 Diesel Particulate Filter Intake Temperature – Data Valid But Above Normal Operating Range – Most Severe Level

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:324 PID:SID 3 SPN:653 FMI:5 Injector Solenoid Driver Cylinder 3 Circuit – Current Below Normal or Open Circuit

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3258 PID: SPN:4340 FMI:5 Aftertreatment 1 Diesel Exhaust Fluid Line Heater 1 Circuit – Current Below Normal or Open Circuit

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:331 PID:SID 2 SPN:652 FMI:5 Injector Solenoid Driver Cylinder 2 Circuit – Current Below Normal or Open Circuit

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3321 PID: SPN:3246 FMI:4 Aftertreatment 1 Diesel Particulate Filter Outlet Temperature Sensor Circuit – Voltage Below Normal or Shorted to Low Source

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3255 PID: SPN:3246 FMI:16 Aftertreatment Diesel Particulate Filter Outlet Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3317 PID: SPN:3242 FMI:3 Aftertreatment 1 Diesel Particulate Filter Intake Temperature Sensor Circuit – Voltage Above Normal or Shorted to High Source

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3312 PID: SPN:3246 FMI:0 Aftertreatment 1 Diesel Particulate Filter Outlet Temperature – Data Valid But Above Normal Operating Range – Most Severe Level

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3241 PID: SPN:4342 FMI:4 Aftertreatment 1 Diesel Exhaust Fluid Line Heater 2 Circuit – Voltage Below Normal or Shorted to Low Source

    DTC TRUCKS

    Rated 0 out of 5

  • SERVICE MANUAL HINO FD.FE.FF.SG 2008

    HINO$34.00

    Rated 0 out of 5

  • MANUAL SERVICE DEUTZ AGROTRON K 90-100-110-120

    DEUTZ$34.00

    Rated 0 out of 5

  • SERVICE MANUAL MACK MP7 2007

    MACK$30.00

    Rated 0 out of 5

  • SERVICE MANUAL HINO FD.FE.FF.SG 2018

    HINO$41.00

    Rated 0 out of 5

  • SERVICE MANUAL 3000 and 4000 Series Gen 5 ALLISON

    Allison$18.00

    Rated 0 out of 5

  • SERVICE MANUAL BOBCAT 442 sms

    BOBCAT$50.00

    Rated 0 out of 5

  • SERVICE MANUAL BOBCAT 444-500-600 sms

    BOBCAT$47.00

    Rated 0 out of 5

  • SERVICE MANUAL DDEC VI Troubleshooting Guide – MBE4000 6SE568

    DETROIT$40.00

    Rated 0 out of 5

  • FUSO$24.00

    Rated 0 out of 5

  • DETROIT$38.00

    Rated 0 out of 5

Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6647 PID: SPN: 6780 FMI: 3 Aftertreatment 1 Diesel Particulate Filter Soot Temperature Sensor - Voltage Above Normal Or Shorted To High Source. An Internal Circuit Error Has Been Detected By The Aftertreatment P (2024)
Top Articles
Latest Posts
Article information

Author: Lilliana Bartoletti

Last Updated:

Views: 6185

Rating: 4.2 / 5 (73 voted)

Reviews: 80% of readers found this page helpful

Author information

Name: Lilliana Bartoletti

Birthday: 1999-11-18

Address: 58866 Tricia Spurs, North Melvinberg, HI 91346-3774

Phone: +50616620367928

Job: Real-Estate Liaison

Hobby: Graffiti, Astronomy, Handball, Magic, Origami, Fashion, Foreign language learning

Introduction: My name is Lilliana Bartoletti, I am a adventurous, pleasant, shiny, beautiful, handsome, zealous, tasty person who loves writing and wants to share my knowledge and understanding with you.